Lantia Pulsar Locator not spawning Namalsk Hardcore server

[Hetstaine]

Hey chaps Been looking for this Locator to do the Lantia jump for four days now. Last week it was spawning every time at the lower room at the research centre where it should, now, not once in over 10 or so visits. Has there been a change? Have also searched A2 and the mountain tower area several times with zero results.

Also, nice server, no stupid mods, guns are not out of control and 1pp, love it!

[zedx3007]

The lifetime of the item is 90 mins, thern it will respawn elseware, if it has been picked up it will spawn 10 mins somewhere else.

It spawns in Tier 3 locations.

Have a look at this map and turn off all and then turn on the tier locations to see those places.

https://dayz.xam.nu/namalsk#5093.75;7412.50;3

Cheers

Z

[richo]

Probably since the new update with the phoenix, the items have changed etc

[NZ_BENNY]

In the Namalsk changelog they changed the spawn of the locator to Phoenix only, found one there yesterday and yes there is a cool down on them now before they respawn

[Hetstaine]

Phoenix, damn. So i need a full nbc suit to go searching right?

Had checked research, A2 and Tower hill mil a few times again in hopes but no joy.

Thanks all.

[Hetstaine]

Got 1 at Phoenix, cheers!

[richo]

Maybe only there huh, I'll keep an eye out.

[Hetstaine]

Maybe only there huh, I'll keep an eye out.

Looks like. Went with a full nbc suit and found it in the rear most section of the rig if you call the ladder up from the water the front. Got the card, the
Emac Flow Controller and now the Locator. Gas mask but no 3d printed suit. As long as i can survive the run i can finally do the jump and spend three minutes there, plenty of shots fired around up near research and the snow mil areas in the last hour so hoping i don't get popped!